|
It did not come with a case or any extras other than a charger. I recently went with the new Makita because buying a replacement [Ni cad] battery was going to be about $40 and is quite outdated with lithium ion technology. I purchased from a local distributor about 5 years ago when it was cutting edge. Over the past 6 months I began to notice the battery just was not giving me the performance it used to. So what did I do with my old one. I think I paid about $120 then. The clutch worked well for my application, dialing up or down it did not over torque at any time or break any delicate material.
At about $70 delivered I would have been goofy to do otherwise. I liked the 15 min coffee break charge time. The Makita came with a useful case [soft side, zipper] second battery, charger and some bits.yes I said bits. It replaced the disposable Skill unit that goes for $30. It seemed like it would spend 15 min in charger & 15 min out.this gets old when you use it a lot. *read my Makita screwdriver review to learn more. I gave it to my soon-to-be retired father in law to use around the house, knowing him he will get years out of it.
I have been using it daily for about 5 years now. You would find that it actually would be a nuisance. I have been in electronics service for over 30 years, and our shops have always used these stick type screwdrivers. But the rest of the features, such as the chuck, and the electronic clutch, are very modern. Pick the correct tool for the job. Having started out with the single speed Milwaukee, then the Milwaukee and Panasonic two speed 2.4 volt drivers,(which are identical), and now the 3.6 volt Panasonic, these are all truly bullet proof and proven Professional products. I'm sure Panasonic will be updating it soon, but the lack of Li-Ion batteries is not that big of a deal.Contrary to a prior comment, you do not want variable speed with a driver of this type.
It is a precision tool that has a surprising amount of power for its size. Products like Black and Decker, Skil, and Craftsman are not even close to being the caliber of this Panasonic driver.This is my 4th driver, and each one has been a steady improvement in features and power. The low speed high torque setting is great for that occasional tough job, or if you need delicate control.It should be noted that this is not a driver for driving long screws into 2x4's. Our shops have been outfitted with hundreds of them over the years, and not one of them fail until they have been completely worn out from many years of daily abuse.This model has been manufactured for many years, which is why it is still using Ni-Cd technology. They work perfectly, and have been a big improvement over prior models, as has been the increase to 3.6 volts, enabling the speed to go to 600 rpm. But it is used primarily for electronics and similar light duty tasks. The 9.6 volt Ridgid is a good driver if you need more power.
WE HAVE OVER 108 OF THESE UNITS IN SERVICE IN OUR SERVICE DEPARTMENT. 50 OF THEM WERE PURCHASED IN 2001 AND THEY ARE ALL STILL GOING STRONG.THIS UNIT IS THE BEST AVAILABLE.
I purchased this product and used it in our shop. When everyone else saw it and saw how great it was, they wanted to order more.
For what it is- simple and lightweight, it's the best we've found so far.They last about 1-2 years of daily use in our production room. We needed a driver that was light to carry for driving small screws, with a good clutch to make sure the screws didn't break out. Any other driver is either way to heavy to carry all day, or way too crappy.The clutch works, the batteries work for about a year. So we recommend it highly for light duty jobs.
|
